Roofing material "Uniflex EPP": technical characteristics ("TechnoNicol"). Features of installation, feedback

When constructing such structures as roofs and foundations, a waterproofing material must necessarily be used . There are many types of coverings of this type on the market today. One of the most effective and popular is Uniflex. The waterproofing of this variety effectively protects the construction of buildings and at the same time it is quite easy to install.

Varieties of Uniflex

There are several types of this waterproofing agent. Determine what is intended for this or that material, it is possible by marking. The first letter in it denotes the type of the material base, the second the type of the top coating, and the third - the type of protective coating from below. This material can be produced:

• On the fiberglass - the letter T;

• On fiberglass - X;

• On polyester - E.

By the type of coating "Uniflex" can be marked K (with a sprinkle) or P (with a polymer film). The first variety is mainly used as a top layer for roofing. The second can be used in the lower carpet of the roof or for waterproofing the basement. Also, sometimes there is a variety marked with the letter M. This waterproofing agent has a small sprinkling and is also often used to protect against moisture from roofs. Thus, on the market there are different roofing materials "Uniflex". "Uniflex" EPP, HPP, CCI, ECP - all these are quite popular varieties.

EPG material

This type of waterproofing unit "Uniflex" is at the moment one of the most popular. Marking it is deciphered as follows: waterproofing on a polyester base (E), covered with a protective polymer film on both sides (P). In fact, the roofing material "Uniflex", the characteristics of which are very good, the brand of EPP is a modern and much more perfect analogue of a well-known roofing felt. At the moment it is considered a waterproofing business class. The EPP material can be used in the same place where the ruberoid was previously used without sprinkling.

Many manufacturers make this roll coating. However, the most popular version of it is the waterproofing of the brand "Technonikol". It manufactures carpets "Uniflex", this company is of the highest quality materials, with exact observance of all put technologies. The specialists of "Technonikol" make this waterproofing agent as follows:

• A special composition containing bitumen, fillers and thermoplastic SBS is applied to the polyester substrate.

• The resulting waterproof material is additionally coated with a protective polymer film.

The advantages of the material so manufactured are:

• Long service life. Protect the design of the house "Uniflex EPP" will be at least 20-30 years in a row.

• High degree of vapor permeability.

• Strength. Unlike the ruberoid, "Uniflex EPP" does not break when pulled, nor does it stretch.

• Large operating temperature range.

Material properties

Next, let's see what the "Uniflex EPP" material has technical characteristics. "Tehnonikol" is a very high quality brand and can be used for waterproofing structural elements of residential and industrial buildings of any number of storeys.

Thus, the technical characteristics of Uniflex EPP, as you can see, are actually just excellent. It is almost impossible to break this material, and it is allowed to mount it even at low temperatures (up to -20 grams). Transport and store Uniflex EPP exclusively in an upright position in one or two tiers. Since the material is flammable, it is not allowed to store it in the immediate vicinity of heating appliances and open flame sources.

Cost

So, simply remarkable is the material "Uniflex EPP" technical characteristics. "Tehnonikol" (the price for this waterproofing is not too high), to all else it is considered a brand also quite economical. Of course, it is worth "Uniflex" more expensive than ordinary roofing paper. But it is considered much more reliable. To repair the roof covered by it too often it is not necessary.

The price for "Uniflex EPP" brand "Technonikol" can fluctuate within 1300-1600 rubles per 1x10 m roll. When installing this material, a special primer for concrete - primer is also mandatory. The means of this variety from the same manufacturer costs about 1800 r. For 20 liters.

Terms of Use

Here are such characteristics of the waterproofing unit "Uniflex EPP". "Technonikol" is one of the best producers of this material. Apply "Uniflex" EPP this manufacturer can both for waterproofing structures of buildings and structures from scratch, and when carrying out repair and restoration work. When performing waterproofing on the new roof it is used as a substrate. Overlay any other variety of "Uniflex", in the marking of which there is a letter K. When carrying out restoration work without removing the strictly waterproof coating, the material may be mounted in one layer.

The manufacturer recommends using Uniflex EPP for both vertical and horizontal or inclined surfaces. Mounted this material using a burner. Therefore, it is practically not used for the waterproofing of structures assembled from combustible materials.

Stages of installation

The procedure for covering the structures of buildings and structures with the "Uniflex" waterproofing device from "Technonikol", whose technical characteristics were disassembled by us above, usually includes the following stages:

• Surface preparation;

• Adjustment of the material;

• Fusing.

How to prepare a surface

Before stacking the Uniflex EPP roll material, technical characteristics ("Technonikol" - in particular) of which are simply excellent, the roof, foundation or walls must be thoroughly cleaned from all kinds of contaminants. In addition, you should carefully handle all crumbling and lagging areas, and then align the surface.

The concrete substrate for the material should be primed. It is recommended to use bitumen BN 90/10, diluted with gasoline in the ratio of 1x3. This will increase the adhesive properties of the surface. Preliminary work can also be carried out, as already mentioned, with the use of a ready-made bitumen primer.

Fit material

This operation must be carried out necessarily. It is worth this material is cheaper than many others, designed for waterproofing surfaces, but it is more expensive than roofing felt. Adjusting the same will eliminate the risk of mis-cutting, and therefore, unnecessary waste. When performing this operation, the ruberoid is simply rolled over the surface to which it will be subsequently fused and cut in the right places.

Fusing "Uniflex EPP"

To install this type of waterproofing, you can use both a propane and a solar burner. During the work, the lower layer of the material is carefully heated. The base itself also passes through the burner. After this, the roll is carefully rolled out by means of long hooks. In order to ensure that the waterproofing is as tight as possible, the strip should be pressed firmly against the surface. After the roof or foundation has been completely glued, all seams should be checked additionally.

Helpful Tips

The roofing material "Technonikol" "Uniflex EPP" is installed with the following recommendations.

1. On pitched roofs with a slope of less than 12 g. Work is done from the bottom up, on the steeper - on the contrary, starting from the ridge.

2. The overlap of adjacent bands should be at least 10 cm.

3. Work on the installation of a waterproofing unit should be done together. At the same time, one person should heat the bitumen with a burner, and the second one roll out the roll and press the material.

4. On flat roofs 4-5 gr. The substrate material EPP should be placed in two layers.

How to repair the roof

The material "Uniflex" is very strong for stretching. However, it is still possible to pierce or cut it. The roof covered with the waterproofing unit "Uniflex" should be inspected from time to time for damage and defects. In this case, first of all, attention should be paid to the presence of detachments and blisters. The departed places must be cut crosswise, deflected "petals", cleaned, smeared with mastic and firmly pressed back to the base. Above, the material is treated again with bitumen and a patch is applied. The latter should be more damage by 15-20 cm from all sides. Also, when inspecting the roof, you should carefully check all the seams. When detachments are detected, the material is smeared with mastic and pressed into place.

So, now you know what the Uniflex EPP waterproofing unit has technical characteristics. "Technonikol" is the best producer of it. By choosing this material, you are guaranteed to get a reliable roof and for a long time forget about the need for its repair.