Convectors electric Timberk: description and reviews

On sale today in a large assortment you can find heaters of convection type. They work quietly, take up not so much space, but look very aesthetically. They are compact, beautiful, and also effective. The devices are suitable for office and apartment.

Their work is based on the movement of cold and hot air, which has a different density. Heavier air masses with low temperature are at the floor, while warm and light air rises upward. In the case of convectors there are two holes, one of them is located on top, the other - from below. They are designed for air of different temperatures. That's why the work of the device can be called very simple. Through the bottom hole cold air enters inside, heats up from TEN and becomes easier, penetrating through the upper opening.

Why choose a convector?

Such devices have many advantages, but the modern consumer, when he finds himself in the store, quite often decides the question of which producer's product to choose. If you also want to install similar equipment in the office or apartment, then it is worth paying attention to the Timberk electric convectors, which are presented today for sale in a wide range. Description of these devices, as well as feedback on them and recommendations for use, you can find below. Perhaps this will allow you to make the right choice.

Description of the convector of the brand TEC.PF1 M 1500 IN

Pay for the heater Timberk this model will have 2900 rubles. It is designed for heating premises, the area of which does not reach 15 m ² . In order for the heater to work in the optimal mode, you can take advantage of the power selection option, it varies from 650 to 1500 W.

Such Timberk electric convectors are compact and versatile, so you can place the device on the wall using the bracket, it comes with the kit. If you need mobility, then you should take advantage of the possibility of floor installation, which requires the use of legs, they are also included in the cost.

Comments about the model TEC.PF1 M 1500 IN

Electric Timberk convectors have a lot of advantages, they are quite often spoken by consumers in their reviews. For example, it is worth mentioning the convenience in operation, because the device has a special indicator, which is located on the control panel. With it, the user can select a specific heating mode. Consumers who choose the Timberk heater mentioned in the sub-title of the model note that the device has a built-in ionizer that works to clean the air in the room from viruses, bacteria and unpleasant odors.

Among other things, the device has a function of frost protection, so when the room temperature falls, the convector will start working. This will happen if the thermometer's column drops below +5 ° C. Consumers also talk about a safe floor installation, which is achieved by a fall protection sensor. Among other things, you will be sure that the safety of operation is at an altitude, as the manufacturer has provided for a multi-stage protection system. If there are children or animals in the house, care should be taken to ensure that they do not get burned when they come into contact with the appliance, because the temperature of the face surface will exceed 90 ° С. Consumers especially note that the device does not emit unpleasant odors while the air in the room is not dried.

Operating Instructions for the Timberk TEC.PF1 M 1500 IN

The operating manual for the Timberk electric convector assumes that you have information before using the device that you should consider where to place it. This should be a place that is far from easily deforming and flammable objects. Before dismounting and stacking the unit in a storage container, make sure that the housing and the heating element have completely cooled down.

The manufacturer gives recommendations for proper storage. If the device does not have to be used for a long time, it must be placed in a cardboard factory package and placed in a cool dry place. The described Timberk electric convectors should not be heated during operation. They are not recommended to store and dry materials, clothing and fabrics. This can cause overheating and further failure of the device. If there are children near the unit, it is necessary to observe the appliance. If the surface is wet, for example after cleaning, do not connect the unit to the mains. It is strictly forbidden to switch on the heater when it comes into contact with water.

Description of convector brand TEC.E7 M 1500

If you want to buy a Timberk convector, you can pay attention to another model, which was mentioned in the subtitle. Its cost is 3000 rubles. The device has a durable and reliable heating element, and the heating power can be selected by you yourself, for this the manufacturer has provided three stages of the regime. The heater has a mechanical thermostat, with which it will be possible to maintain a certain temperature in the room. The set includes feet for floor installation. Mount this unit in a room with a surface area of 18 m ² or less. Otherwise, you may encounter a power surcharge or insufficiently efficient operation of the unit. The dimensions of the device are 400 x 640 x 110 mm. The capacity of the equipment is 1.5 kW. You can install this model not only on the floor, but also on the wall. The weight of the device is only 3.8 kg, which indicates the possibility of mounting on a wall that is not capable of withstanding heavy loads.

Reviews about the convector TEC.E7 M 1500

This convector Timber has an exclusive author's design. Consumers like the modern multi-directional heating system for mixing incoming air streams. Among other things, this device is able to save electricity, which reduces consumer costs. With the mechanical control panel, even an elderly person will be able to cope. Buyers especially note that the heating element has an unprecedented service life. Install the equipment can be even in the bedroom, because it works completely silently. You can not be afraid that a fire will occur if the device falls, because it has a fall protection sensor.

Operating Instructions TEC.E7 M 1500

If you notice that the plug or the power cord has some damage, the convector should not be turned on. Otherwise, a person may be electrocuted. Change the power cord only at authorized service centers. Should be engaged in these works specialists. The electrical circuit of the Timberk convector will allow professionals to do repairs, but you should not do it yourself. In this case, you may encounter a complete breakdown of the device, which will not fall under the warranty service. It is not recommended to use a convector outside the room in open spaces. The installation in swimming pools, bathrooms or showers is excluded, as well as in those places where there is a possibility of water droplets on the surface during the operation of the device.

Description of the convector TEC.E0 M 1500

If you are looking for an electric wall Timberk convector, then you can consider the characteristics of the model TEC.E0 M 1500, the cost of which is only 2000 rubles. This equipment is used for spaces that do not exceed 15 m ² . The weight of the device is 3.8 kg, and its overall dimensions are limited to 450 x 630 x 80 mm. Such Timberk electrical heating convectors are equipped with not only support legs, but also a wall installation kit.