Homeliness, Tools and equipment
Convectors electric wall - the heat of your home
Convectors electric wall - it's light heating modules, allowing you to minimize the time from their purchase to heating the room. The source of heat in this device is a heating element located in the lower part of the hollow metal casing, which is controlled by a thermostat. At the heart of the electrical appliance is the natural convection of air. With uneven heating, the lower layers become lighter and rise upwards, cold air flows into their place. The design allows to distribute heat evenly, without creating additional noise in the room.
It is not difficult even for an inexperienced customer to independently install a heater. In a room that requires heating, a frame is attached to any wall using screws. Then the module is hung on it. If you additionally purchase a set of legs (castors), then in the future you can use the device and as a mobile floor, to some models the roller feet are supplied as part of the delivery.
The correct choice of installation site will ensure the accuracy of the set room temperature control. Electric wall convectors must not be exposed to direct external air and be installed on cold surfaces. When using a heater in the bathrooms, the models are fitted with a splash-proof version (class II protection). According to the recommendations, the devices should not be installed under a network outlet, and it is desirable to exclude access to the management of a person in the bathroom.
Convectors electric wall, with the use of programmers, make it possible to create the basic heating system of a country house, apartment, cottage. Most of them can work and maintain the set temperature around the clock. The built-in flameproof sensor immediately triggers with overheating and switches off the device. The cost of the system is lower than traditional (with electric boiler) 2-3 times. The popularity of devices is growing due to 30% of energy savings, which is obtained during the operation of devices such as electric convectors. Buyers' comments say that it is good to use them as a reserve for the off-season (cold period after switching off central heating), heating of winter gardens, glazed loggias, shopping pavilions, garages.
Uneven room heating and the ability to pick up dust by convective currents, as well as the deposition of dust on the inside of the device, leading to a decrease in efficiency, is a problem that must be taken into account when installing this heating system.
Similar articles
Trending Now