How to make a wall of drywall

Quite often during repairs in the apartment there is a need to move the walls in order to more functionally distinguish the living space. Previously, for the construction of new walls, it was necessary to make a masonry of blocks or bricks, which is a process that requires not only time, but also very substantial material costs. However, technological progress does not stand still, and new materials appear on the construction market that significantly facilitate the work of not only professionals, but also home-based masters.

One of such materials is a gypsum plasterboard sheet, due to which the process of building new walls can not only be significantly accelerated, but also much cheaper. Drywall not only allows you to erect a wall or build a partition in a relatively short period of time, but also guarantees a perfect final result. Therefore, if there is a need to re-plan the apartment, it is best to think about how to make a wall of drywall. Moreover, this material, simple and easy to use, gives great opportunities for realizing the most daring design ideas, and the wall surface is smooth, ready for final finishing with any chosen material, including ceramic tiles.

So, if the question of how to make a wall from drywall does not scare, you can proceed directly to the construction process.

To do this, you need to purchase the right amount of plasterboard sheets (in accordance with the planned plans), special guide profiles, fastenings to them, dowel-nails and screws. To buy materials it is necessary with a small margin.

Installation gipsokartonnyh partitions and walls begin with the construction of the frame. To the ceiling and walls are attached guide profiles made of metal with the help of special dowel-nails. Fasteners must be made reliable, otherwise the whole construction will stagger or, worse, it may fall. Then, vertical racks of the same profile are mounted to the main guides along the entire future wall. The width of the step between them must correspond to the dimensions of the drywall sheet.

In some instructions on how to make a wall of gypsum board, advise (in order to save) to replace the metal guides with wooden blocks. Doing this is not recommended, because the tree is a material that can deform with time, and the shape of the wall will change along with the frame. Therefore, you do not need to save on guides. It is better to save on the procedure and think about how to install drywall yourself, without resorting to the services of a construction team.

So, a reliable frame is ready. Now it is necessary to attach to it self-tapping gipsokartonnye sheets. First, only one side of the future wall is closed. Then all useful communications are laid: telephone and television cable, electrical wiring, Internet and other planned benefits of civilization. After that, the insulation is laid in the niche - polystyrene, mineral wool or other selected material, and the wall itself is sewed with plasterboard on the second side. Now the wall is not only almost completely ready, but also reliably protected from penetration of extraneous sounds and loss of precious heat.

All. You can proceed to the final stage - the finish. First, it is necessary to treat the entire surface of the wall with a special primer. Then all the joints between the sheets should be glued with reinforcing tape and puttyed. If in the future the wall is planned to be painted or glued with wallpaper, then it is necessary to thoroughly penetrate the whole surface. If the wall was mounted under the ceramic tiles, no additional work is required.

Perhaps, a lesson on the topic "How to make a wall of gypsum board" on this can and finish. It's time to apply this knowledge to practice.