Can I use profiled sheets for the fence?

Fence - an integral part of the suburban area. And only on you will depend on how he will end up looking! You can install a poor fence, but you can use profiled sheets for fence.

But before the beginning of such a responsible construction it is important to remember at least the school course of geometry and make careful calculations. This is necessary, since at the very end of the fence construction you can find that the profiled sheets for the fence have run out, and there are no more such in the warehouse. Agree that the fence of heterogeneous material will look ridiculous.

In addition, in advance decide the issue with the installation of automatic entrance gates. If you decide to fork out and on them, you should order them in advance, as they are made strictly according to individual sizes, and the production time may well be up to a couple of weeks. By the way, this approach is justified by the fact that in some cases, the color of corrugated board you will choose, based on the characteristics of the gate. After all, a photo of fences made of red profiled sheet , perfectly "in harmony" with the gates of a blue hue, look quite amusing.

Now let's talk about the procedure for installing the fence. As in any construction, there are some nuances here. In particular, it is best to put such a fence on a strip foundation that can withstand soil vibrations well. The closer the groundwater is, the deeper you need to dig a ditch for the foundation. If the soil is clayey, then you can not stand on ceremony, but simply drive steel pipes into the ground. In other cases, it is necessary to make a qualitative foundation, as the fence can collapse, and the gate will simply warp. If the gate is automatic, then the foundation must be made in all cases.

But to choose profiled sheets for a fence is only half of the matter. After that, you need to buy profile pipes. If you plan to attach sheets of material directly to them, you can buy round ones, if you want to enclose them with a brick, then it's best to pick up square ones. So you will spend a little bit of mortar on the masonry, and the pillars themselves will make it easier. In addition, when installing automatic gates, you should not save on facing bricks. The fact is that otherwise the appearance of your fence will not be too impressive!

From the same facing material it is desirable to make the finish of the basement section of the ribbon foundation. This is especially important when your site is not particularly singular: the profiled sheets for the fence in the form of a rising "snake" look wretched. It is better to arrange them on the same level, raising a higher foundation foundation.

As for the sheet itself, do not save, take only standard, painted in the factory, and do not cut them with the help of a Bulgarian! The fact is that the cutting disc will heat the metal along the edge of the cut, breaking its structure and tearing off the protective zinc layer: the next year your fence will begin to rust intensely. If you have to cut metal, treat it properly with special coatings, which protect it from corrosion. In this case, the corrugated board for fences (the price of erection of which is not too low) will serve you more than a dozen years!