We make the door-compartment with our own hands

To create a compartment door with your own hands is easy, for this you need to have elementary skills in construction.

To begin this type of work is necessary with the dismantling of the old structure. Also in many apartments there are such niches, which are closed with a modern door-compartment, you get an excellent wardrobe.

Begin to install interior doors-compartments with your own hands, you need to measure the opening where they will be and only after that you can go to the nearest building store to purchase door leaf, rollers, guides and screws, and you will need a screwdriver.

Therefore, before you start making the door-coupe with your own hands, you need to purchase the necessary materials.

If the opening is not very large, then a single-leaf door is sufficient, and if it is of considerable width, it is better to install a double-leaf door, then you will have to buy two canvases. It should be noted that when buying it, you must pay attention to the fact that it should be 5-7 centimeters wider than the doorway.

You can not worry about the necessary additional materials, as they are always included in any specialized building store. Door handles you buy at your discretion, their number will correspond to the number of door leaves. Also, do not forget to buy a wooden beam measuring 50x50 mm, its length should be twice as large as the doors you create with your own hands.

When installing the doors, the first step is fixing the rail to the wooden beam. It must be done reliably, for which fastening screws are used. Now we fix the bar to the top of the door, then later the guide rollers join it . Using the existing adjusting nut, the bar must be set in a horizontal position.

Then at the bottom of the door using a chisel, you need to make a special groove in which the lower roller will then move. It is attached to the floor using self-tapping screws.

Now we must very carefully approach the installation of the bar, since its incorrect fixation can lead to the spontaneous opening or closing of the made-up coupe with one's own hands. When securing the beam, you need to use reliable anchors and therefore the above part of the work is best done together, so you can set and fasten the beam accurately in a horizontal position.

Also, pay attention to the installation of the lower guide roller, which must be exactly under the guide bar. If this is not observed, then there will be a skew, and the doors will not open properly. Correctly to establish the bottom roller it is possible by means of a building plummet, and if it is not present, it is possible to use any string with a cargo.

Now it remains only to put the door leaf on the lower roller, and then it is finally fixed on the upper rollers. Also, do not forget to install special limiters that come with the kit, otherwise the door can go beyond the guide bar when opening.

We perform the final work, which consists in closing the bar with the clypeus, for which you need to use special finishing nails. The bar is also closed from the end faces.

The final adjustment of the door-coupe is carried out and only after they are fully adjusted, you can proceed to install the right handles, with the location of which will be easy to determine.

Precisely for the same technology, you can make doors for the closet with your own hands.

Thus, the created doors-compartments significantly save space, but one of their drawbacks is that they are not as tightly fitting as usual, and soundproofing will be worse, but sometimes you need to sacrifice something for additional convenience.