Two ways to re-use cartridges in Phaser 3100 MFP from Xerox

Phaser 3100 MFP . A multifunctional entry-level device with acceptable technical characteristics and very affordable cost is the Phaser 3100 MFP . The main problem that the owner of this peripheral solution encounters is the reuse of the cartridges after the print counter has been activated. It is this decision that this material will be devoted to.

Cartridges. Their models and specifications

от компании Xerox может работать с одной из двух моделей картриджей: 106R01378 и 106R01379. The Phaser 3100 MFP printer from Xerox can work with one of two cartridge models: 106R01378 and 106R01379. In the first case, the limit is 2200 sheets, and in the second case, 4000, and this is an improved cartridge for this device . In the initial configuration of the MFP is the first modification of the cartridge, but in practice it is preferable to use the improved modification. After the page counter has counted 2200 pages for 106R01378 and 4000 sheets for 106R01379, the cartridge is blocked. It can no longer be used for copying or printing. But there are two ways that you can still re-use this mechanism.

Method one: firmware

Phaser 3100 MFP, – это замена его внутреннего программного обеспечения или, как ее еще иногда называют, прошивка. The first way that allows you to reuse a cartridge in the Phaser 3100 MFP is to replace its internal software or, as it is sometimes called, firmware. The essence of this operation is that the internal program code of the printing solution is replaced. If the old shell does not allow the reuse of cartridges, then in this case this check is blocked. This operation is performed once, and after that, there are no problems with re-using the cartridges. Its only drawback is that the software in this case is not licensed and the terms of the guarantee are violated.

Option two: the chip

Phaser 3100 MFP . It is not necessary to re-use the Phaser 3100 MFP to reuse the print cartridge . As an alternative, a microchip stands that can be mounted on the cartridge. With the help of such a semiconductor element, the counters are reset, and the printer then determines the cartridge as new. But after the development of the print resource, the microchip will have to be re-purchased and changed. The pluses in this case can be attributed to the fact that the terms of the guarantee are not violated. But the minus is the need to constantly buy such chips.

What is better to choose?

Phaser 3100 MFP первый способ, который заключается в обновлении программного обеспечения и установке сторонней прошивки. Whatever it was, and the most justifiable from a technical and economic point of view to use to extend the life of the cartridge in the Phaser 3100 MFP is the first way, which is to update the software and install a third-party firmware.