Replacement of the radiator of the VAZ-2114: useful recommendations and notes

When it comes to the fact that you need to replace the radiator of the VAZ-2114, then immediately there is a huge number of difficulties. For example, it is not possible to dismantle the device or, conversely, there are difficulties in the installation. Let's see what and how to do in order that it does not take much time and effort.

When you need to replace the radiator stove VAZ

As practice shows, there are only a few reasons why you might need to install a new device. One of them is the leak in the radiator. Unfortunately, it's much easier to buy a new one both in time and in money. Regardless of the size of the hole, the device will not fully cope with its immediate task. If you come to the service, the radiator will be repaired, but after a while it will leak again, and for repair will take a good amount.

Also, the device can jam. In this case, it also needs to be removed, but the situation is not so hopeless and you can try to repair it. Do this with the help of a brownhorn. You can try blowing with compressed air. But it is necessary to avoid too high pressure, which can not withstand the radiator. As a rule, there are no other breakages, so most often the device is subject to immediate replacement.

How to choose the right radiator

So, we are facing a difficult choice. The fact is that replacing the radiator of the VAZ-2114 stove has several nuances. For example, the factory device has a high degree of heat transfer. But in the market it can not be found, so you'll have to be content with what's there. It is not recommended to buy used, in principle, it is clear why. In a month or two you will need to purchase a new radiator, in simple words - to spend again.

As practice shows, the DAAZ manufacturer is very popular among car enthusiasts, whose products are exceptionally high-quality. Also, the heat transfer coefficient will be pleasantly surprised. We can not say that the radiator of the VAZ-2114 can be aluminum or copper. It is difficult to say which one is better. Both copper and aluminum radiators have their advantages and disadvantages, which are expressed in terms of service life, heat transfer, etc.

How to make a replacement yourself

First of all, we have to completely drain the coolant, it's quite simple. After that, we remove the dashboard, this is done in order to gain access to the radiator. In order for the procedure not to take a long time, it is recommended to dismantle the panel partially, and not completely.

You can remove the glove compartment and console, after which you need to remove the fastener from the left side. It is advisable that there is an assistant who will pull out the panel, and you at this time will remove the radiator. There is also a second method: to do this, unscrew the fasteners on both sides of the panel. Then you need to loosen all the brackets.

Now the replacement of the radiator of the VAZ-2114 is not a problem. But before removing the device, it is necessary to disconnect all wires coming from the electric engine of the stove. We see four nuts fixing, which must be unscrewed. The final stage is the weakening of the clamps on which the radiator connections are attached. That's basically it.

Conclusion

As you can see, replacing the radiator of the VAZ-2114 stove is not such a complicated procedure. Since the installation is almost the same, there should be no problems. The only thing that needs to be done is, if necessary, to change all branch pipes and clamps. But you need to look at their condition, if their state is satisfactory, then you can leave the old ones.

Also do not forget to refill the coolant. After starting the motor, the stove should warm well. If it works poorly, then, probably, an air stopper was formed. All work must be carried out in a ventilated room. The car can be put on the handbrake. Keep in mind that if the replacement of the radiator of the VAZ-2114 is made immediately after the machine has been running, the device will be hot, it is better to wait a little.