Probably every second person would like to have his own pool. And this opportunity is the majority of owners of private homes. Many have become accustomed to the stereotype that such an idea requires a fairly large investment. But in fact, this is not entirely true. An excellent low-cost solution is the installation of a frame pool. This option is more than affordable. Even those who have a dacha near water bodies do not always have the opportunity to swim. Since not everywhere there are clean water, but in the hot summer everyone wants to be able to cool a little in cool water.
In the traditional frame pool in the role of supporting walls are the steel components. On top of the details should be a strong film, the necessary plastic beads and devices for water filtration.
It is very easy to make a water change. In the bottom there is a special tap, to which it is necessary to bring a hose, dirty water will flow from it. To maximize the benefit of this design, you can use the used water to irrigate a plant, garden or garden.
This article will provide general instructions for installing the frame pool. A minimum of two people are required for this work. The more people will participate in the erection, the faster and easier the expected result will appear. The pump should be installed at the end of the entire assembly. The reservoir should be placed on as level surface as possible. It should not have any stones, knots, small depressions and other similar things, as all this can lead to spoilage of the material. The storage box is best preserved, it can come in handy when reassembling and further storage in winter. The installation of the Intex framework should take place on the litter. The site should be prepared in advance. Above it is the base of the pool (cloth). It is necessary to pay attention to the direction of the drain hole, because in the future it will be necessary to send water to the required place.
From the hose remove the drain valve and wait for the heating of the fabric of the future design. Then it is necessary to insert the beams into the intended passages. It is very important not to move the material on the ground, because The fabric may be damaged. Therefore, the installation of the frame pool should be carried out immediately in the place of further use. The location of the pond should be at a distance of the full length of the elongated pump cable from the outlet (right next to it, putting the pool strictly is not recommended). The horizontal beam must be pushed into the hole prepared for this, then connect it to the T-hinge using a bolt and rubber gaskets. The installation of the frame pool in this mode should take place in one direction. When the alignment of the contour ends, it may be difficult to connect the parts. To do this, they are recommended to raise by 5 cm and simultaneously lower, connecting at the same time.
There are many subtleties of assembly, and it is recommended to observe them all. The work may seem a little laborious, but the result will surpass all expectations. Reinstall the frame pool Must pass confidently and automatically. For today it is one of the optimal, inexpensive, but high-quality options for swimming pools.