How to open a machine without a key.

Sometimes in the life of car enthusiasts there is a situation where you have to look for a way to open a car without a key. Well, if the key is missing or the lock breaks the owner found next to his house or garage - in this case, you can simply drill this lock with an electric drill. And if your home is far away, you will have to solve the problem with the help of improvised means.

The most important thing is not to get nervous. Calm down and look around more closely. Look for either a piece of hard wire, or a thin knitting needle, or a welding electrode. If you find an electrode, then before starting work, you need to remove the insulation from it so that the wire is exposed. If any of the above are found, then half the way to solve the problem, how to open a car without a key, consider that they have already passed.

Go to the door from the driver's side and pull out neatly two hundred to three hundred millimeters of the glass sealer, which is located above the door handle (usually this length is enough). In case the seal is not pulled out, it should be pinched by a flat thin screwdriver, and if there is not one under your hands, then a piece of wire. We bend this piece of wire in such a way that both ends form an angle of ninety degrees between each other, and one of the parts must have a length of at least ten to twenty millimeters. In this way you will get a kind of improvised hook. Universal picklock is ready.

How can you now open a car without a key with it?

We take the wire so bent and insert it into the gap after crocheting the crochet down. But the long part of it must be arranged so that it is strictly parallel to the lock chip. The end of the hook must be parallel to the gap and point in the direction of the rear doors. The wire slowly and gently lowered down until it stops, leaning against the lock. Now it is necessary, while continuing to hold the wire as deep as possible, to advance it gradually about thirty millimeters to the left. Then, also gently and gently, you need to lower it down about 30 mm too. And after that it is necessary to move the wire again about the same distance, but already to the right side. Now you can already try to pick up your lock mechanism with your hook-lock. Pull the wire up, and the problem of how to open a car without a key is almost solved - the lock should open. Just do not forget at the end of the process to return to its place the glass seal.

It goes without saying that the data in this article are only approximate and not suitable for all vehicle models. The linear parameters of the improvised master key specifically for your car may differ from those suggested by us in greater or lesser degree. So just in case, in order to know how to open a car without a key (it's yours), at leisure, you need to practice a couple of times, so that if there is such a need, do it quickly, accurately and without unnecessary hassle. But you need to remember that the wire that you are going to use in order to open the car must be of sufficient strength and be able to withstand an effort of seven kilograms. If these conditions are not observed in the process of opening the lock, the hook made of it can simply straighten, then everything must begin from the very beginning.

Not knowing what can happen on the road with you at any time, you need to have all the possible skills, including knowing how to open a car without a key.