Has the petrol trimmer broken? Repairs with their own hands are possible!

Gasoline trimmers are absolutely indispensable in the elimination of weeds in the backyard, as well as in the preparation of hay. Yes, as a grandfather "litovka" they also proved to be irreplaceable helpers. But there is only one problem: even the old braids after the season had to be repaired.

What to do in the event that the gasoline trimmer broke? Repair in a service center is not a cheap pleasure. Is there any chance to somehow correct the situation on my own?

What not to do

It is known that prevention is much preferable to treatment, but do not forget to take care of the instrument so that it does not need repairs. First of all, after every 15 minutes of work, you must give the device at least ten minutes of rest. In addition, you do not need to mow the grass above the one indicated in the operating instructions.

If prevention did not help

What if the gasoline trimmer broke after all? Repair yourself - a good option! Immediately stipulate that we will talk more about engine malfunctions, since almost every one can repair a broken bar. In extreme cases, you can simply fix it with a tire and clamps.

Ignition

So, if there are problems with the fact that the tool does not start or stalls right after the start of work, first you need to pay attention to the state of the ignition system. Try to unscrew the candle and inspect it. In the case where the device is completely dry, there must have been something wrong with the fuel mixture.

Is the candle wet? Completely "showered" with a gasoline-oil mixture? Your gasoline trimmer, the repair of which we are trying to describe, has problems with carburetor adjustments. This often happens when the non-specialists tried to deal with it. If you do not have experience, we strongly advise you to contact the service center, as by your actions you can completely burn the entire piston system.

However, not everything is so bad: if you violate the rules of cold start, all the while trying to pump up the fuel mixture, then it can easily lead to dropping.

It's different when the candle is covered with a thick layer of black carbon. In this case, the gas trimmer, the repair of which we describe, was exposed to a poor quality fuel mixture. Maybe, again, it is in the wrong adjustment of the carburettor, which gives out a too saturated fuel mixture. Just replace the candle.

Fuel supply

Often the absence of gasoline into the combustion chamber is explained by the fact that a lot of dirt accumulated in the gas tank, which simply hammered the supply hose. Disconnect the fuel hose. If fuel does not flow from it, then a clogged fuel filter or breather is to blame. The latter can be cleaned with a needle, and the first is desirable to completely change once every three months.

Among other things, the repair of Petrimon trim tabs "Patriot" often requires replacement and air filter. Being clogged, it prevents the formation of a normally enriched fuel mixture.

And more: often in everything is to blame stuffed with nagar silencer. It must be dismantled, rinsed in kerosene or burned on a burner. This is especially often done by those for whom the repair of Husqvarna gasoline trim tabs is a routine job.