Erection for the bath with their own hands brick oven: features and description of the process

Keeping the body clean is one of the necessary conditions for a healthy lifestyle. An important role in this process is played by water procedures, which, combined with high temperatures, also give a good quenching effect. A full implementation of the process is possible only in the bath. To achieve the necessary temperature-humidity regime, an efficient heater is needed. The construction of a brick oven for the bath with their own hands is a complex and responsible process.

Laying the foundation

The basis of this construction is the cast foundation, the laying of which precedes the beginning of the work. The pit is excavated to a depth exceeding the freezing level of the ground. For different localities, this parameter can be from 0.7 to 1.2 meters and depends largely on the composition of the surface layer. The construction of a stove for a bath with his own hands made of bricks assumes the creation of a cast waterproof foundation on a sand cushion.

Strengthening of the foundation is carried out with the help of steel reinforcement of a certain diameter. The connection of the rods to the frame can be carried out by electric welding or binding wire. Pouring of concrete is done in pre-assembled formwork. The device for the bath with their own hands, a brick oven is made after laying on the foundation waterproofing of roofing material, which prevents the destruction of the structure.

Basic construction operations

The foundation is considered to be fully ready for the commencement of work after the expiration of the period necessary for complete drying and shrinkage. Masonry, as a rule, begins not earlier than a month after the foundation is poured. This time can be used to purchase and transport the following building materials:

1. Brick, clay, fireproof.
2. Carefully washed sand.
3. Purified clay.
4. Cement grade 500.

The device for the bath with their own hands, a brick oven is made on sandy-clay mortar. Its components must be thoroughly cleaned of impurities. Red clay is mined from a depth of at least 1.5 m and is soaked in water for several days before application. In this colloidal solution, sand is added in a ratio of two to one.

Simultaneous preparation of a large number of masonry mixture is irrational. The period of its use does not exceed several hours, after which it hardens and becomes unfit for further use. Begin laying should be from the socle, which leads the oven to the floor level. When performing the operation, it is necessary to strictly monitor the horizontal surface of the surface with the help of a building level.

Furnace arrangement for a classical bath

Erection for the bath with their own hands, a brick oven is produced mainly indoors. In its design should be present the main parts: ash and furnace, grate and chimney. In addition, a metal container is installed on the oven to heat water, and a heater is placed on top of the furnace. Categorically it is not recommended to use river and sea stones for these purposes.

Installing stoves, fireplaces made of bricks - a difficult and responsible occupation. To achieve a certain master level, you need experience, skill and knowledge. You can get them only in the process of working and observing real experts. However, in this there is nothing impossible.