Water supply in a private house. Installation and installation of the water supply system

In the construction of individual housing is one of the important moments - the installation of water and sewage. These two systems are closely interrelated. Is the water supply in a private house a norm, and not a luxury item? As it was just recently. Modern man does not think his existence without conveniences, and this is quite understandable.

An interested person can make a water pipe in a private house with their own hands. It is important to correctly calculate and design it at the design stage of the house. During the erection of the foundation, it is necessary to perform shtroby and prepare channels for laying pipes. At the same stage, the connection to the centralized network is performed, if there is such an opportunity. The pipe is cut in and out.

Often the water supply in a private house, especially when it comes to suburban construction, implies the organization of an autonomous water supply system . In this case, there can be two solutions: a well or a well. If the water supply in a private house is planned for seasonal short-term use, then the requirements can satisfy the well. This option will be cheaper than drilling a well, but we must remember that the water quality in the system will be much worse. Most likely, this liquid can be used only for technical purposes, or subjected to a multi-stage clean-up.

If the water supply is designed for regular use, including in the winter season, the best option for an autonomous system will be a well. The quality of water compared to the well is much higher. In addition, it is recommended to install filters on the inlet for cleaning. This will favorably affect the work of all appliances that use water, including washing machines, dishwashers and even irons. Also in the kitchen, an additional cleaning filter should be installed to produce water suitable for drinking.

Installation

Water supply in a private house can be divided into two main components - the outside and the inside. It does not depend on the method of connection.

As it was already written earlier, even at the stage of project development, it is necessary to prepare and carefully consider the design of the water supply and sewerage system. Work on laying the outside of the network can be performed already at the stage of foundation work. In this case, the pipes leading to the house should be laid underground. There are two options: either below the freezing level of the soil, or the pipes must be additionally insulated. This is done in order to avoid freezing in the winter.

Work on building communications within the building should be carried out before the interior finishing, in order to be able to test the system without causing damage in case of leakage. For more rational operation of the pumping station, in the case of an autonomous system, it is customary to use storage tanks, from which water flows directly to the appliances. Direct swap from the source to the device is suitable only in case of irregular use. Otherwise, this leads to additional energy consumption and wear of the pumping system.