Article on how to make flowers from satin ribbons

From the satin ribbon, you can make a lot of stunning jewelry. Everyone can learn how to make beautiful bows, gift ribbons, various flowers from satin ribbons with his own hands. This will decorate any thing: dresses, hair rims or gifts for any holidays.

Next, consider in detail two options, how to make flowers from satin ribbons.

Option 1. Decoration in the technique of "Kanzash". It is perfect for brooches, rims or pegs. For work, you will need: satin ribbons with a width of 5 cm of preferred colors, a piece of cardboard, a wire for a stalk, a lighter, scissors, a needle with threads, an awl, a decorative lace or a green ribbon.

1. Take a tape to create petals, measure 7 petals of 7 cm each and cut off.

2. We bend one obtained cut in half so that we get a rectangle 7 cm long, 2.5 cm wide, and the front part was inside.

3. We glue one side of the part with the lighter, so that the folded sides are connected with each other, and we turn the product out.

4. Next, the long sides of the future petal need to be slightly bent inward to get the strips 5-7 mm, and stitch or scorch the tips.

5. Turn the piece of satin to the other side and connect the lower parts with a lighter. The petal is ready, according to this scheme it is necessary to make six more pieces.

6. When 7 petals are ready, it is necessary to sew them together gently in the form of a flower. Quite recently it was completely unclear how to make flowers from satin ribbons? But now the base for the flower is ready, move on.

7. We will make the middle. To do this, cut out a cardboard circle of the required size.

8. Using an awl we make two small holes in it, thread the wires into the holes obtained and twist both ends into one stem.

9. Cut a circle of a larger size from the tape than the cardboard. It will be needed to create the core of the flower.

10. Next, we lay a piece of cardboard with a satin cloth.

11. We pass the wire of the obtained product to the center of the cross-linked petals.

12. We make one more cardboard circle with the wire threaded into it and wrap it with a green ribbon.

13. With a red-hot awl in the middle of the part we make a hole and pass a wire into it. If desired, you can also wear a piece of green organza. So disappear the flaws of the flower from the back.

14. Turn the wire around with a green decorative cord. Our flower is ready!

There is another option, how to make flowers from satin ribbons, for example chrysanthemum. It is done very quickly and simply. To work, you need a satin material for a bud 5 cm wide, 1.5 m long, for leaves - 5 cm wide and 20 cm long. Let's get to work.

1. On the satin ribbon, intended for the flower, we will pass a simple zigzag stitch.

2. We pull the threads so that the ribbon is wrinkled.

3. To make the leaves, you need to do the following. Piece of green satin material put upside down and bend the edges to the middle to make a triangle. To sew its lower edges and pull off the seam. Do the same as the second leaf.

4. We perform the collection of the flower and fix the greens to it. Chrysanthemum is ready.

There are many other ways to make flowers from satin ribbons fast, beautiful and very original. These can be chrysanthemums, peonies, carnations, chamomile. They are perfect for pins, dresses, curtains. You can simply create a bouquet for decorating the interior. In any case, now you will not be disturbed by the question: "How to make flowers from satin ribbons?"