Proper connection of the washing machine to the sewage system

Since without a washing machine it is difficult to imagine the life of any modern person, people often have questions, just related to its operation. In particular, not everyone knows how the washing machine is connected to the sewer.

But this may depend not only on the term of its service, but also on the possible waste associated with the flooding of neighbors!

Read instruction

In order to better understand all the technological requirements for the process, be sure to read the instructions that came with your equipment. Note that the connection of the washing machine to the sewage system must be carried out only according to the rules. General requirements for connection you will find in our article.

Looking for a place

Normal operation of the equipment will be very difficult if you do not put your car in the right place. By this we mean the position from which the drain hose will be easy to reach to the sink, bathtub or shower stall.

But ideally, the connection of the washing machine to the sewer should provide for its separate conclusion. So remember that in the optimal case, a separate drain pipe could be connected to the machine.

Alternative Places

It can often happen that there is simply no room for a similar volume in the bathroom. In this case, it is appropriate to put the car in the kitchen or even in the hallway. But in the latter case, you obviously have to use an extension hose, and this is not always permissible.

And the very connection of the washing machine with your own hands seldom assumes that you will have to chisel the wall in order to remove the hose through it.

Mounting Features

As a rule, cheap models do not have a check valve, which would prevent spontaneous discharge of collected water from the tank. In this case, the manufacturer immediately warns that the drain hose must be slightly raised. As a rule, this height can not exceed half a meter.

Bending it should be as smooth as possible, because otherwise the pump has too much load, because of what it can easily fail. This connection of the washing machine to the sewage system is fraught with the fact that the electricity consumption will increase dramatically.

We have already said that, in the optimal case, the connection must be made directly to the drainage pipe of the sewage system. To do it professionally, get a splitter in a specialized store. That the water does not leak from it, there is a rubber seal.

With regard to power from the network. Any normal manufacturer in the manual will write that the connection scheme of the electric motor of the washing machine must necessarily provide grounding.

It is very desirable for the machine to feed a separate cable from the shield. It does not hurt to protect it with an automatic device, since the peculiarities of the behavior of electrons on the expanses of domestic power grids rarely yield to a logical justification ...

The grounding wire must always be carefully insulated under all conditions, since otherwise very unpleasant cases are possible.