"Makrofleks" - mounting foam, which is trusted by professionals

Today under the brand Makroflex is produced more than ten different products. These are adhesives, sealants, paints, solvents and professional construction tools. All of them are produced in accordance with international quality standards and meet sanitary and hygienic standards. But the main product, the quality of which is proud company "Macroflex" - assembly foam.

On sale you can find several varieties of this product. Like other building compounds, the foam is produced for domestic and professional needs. Professional mounting foam, as a rule, is applied with a special gun - for more accurate dosage and accurate application. Household - does not require additional accessories, a plastic tube is attached to the balloon for ease of use.

Foam mounting "Macroflex": technical characteristics

The product of this brand is one-component, that is, it is ready to use initially and does not require mixing of various components. It is based on polyurethane foam and other components. "Macroflex" is a mounting foam, which is in a cylinder under pressure. When applied, it expands 2-3 times, and then hardens under the influence of moisture contained in the air. Depending on the external temperature, the width of the filled seam is determined and the expansion coefficient, which possesses "Macroflex". Mounting foam after hardening becomes porous and densely elastic, provides excellent heat and sound insulation, repels moisture and prevents the formation of mold, fungus, penetration of microorganisms into seams and joints.

Scope of application

"Macroflex" is a mounting foam, the characteristics of which allow it to be applied on various types of surfaces. Due to the high adhesion (this property ensures a good "adherence" of foam to the surface), it is used for wood, glass, stone, concrete and other building materials. In addition to the above resistance to moisture and its harmful effects, the hardened coating is resistant to acids and alkalis, but requires additional protection from UV rays.

Macroflex Foam Foam is perfectly suited for sealing all types of joints and joints in the following types of work: installation of door and window units, installation of roofing, sealing of utilities, installation of sound and heat insulation structures.

Recommendations for use

"Makrofleks" is a mounting foam, work with which, like with most other high-tech materials, requires strict adherence to certain rules. The recommended working temperature is from +5 to +30 degrees. It is desirable that the width of the welded seam is in the range of 1 to 6 cm, if the hole is larger, you must first fill it with a suitable heater. The surface that will be covered with mounting foam must be prepared in a standard way: clean the dirt and residues of old mounting materials, dry and degrease. In some cases it may be necessary to treat it with water from a spray gun (if the air humidity is not high enough for normal foam hardening).

Full cure (hardening) of the mounting foam occurs within 3-4 hours. After that, its surpluses are cut off if necessary, and the seam is ground with putty or colored.