Lamps with motion sensor: continuous economy

Lamps with a motion sensor will become reliable assistants in the house. They will increase security in all rooms. Lighting will turn on wherever you appear, and automatically turn off where no one is. LED lamp with a motion sensor will save energy by at least 40-50%.

Installation of such devices is one of the main steps on the way to automation of a dwelling or office. Lamps with a motion sensor work according to the following principle: as soon as the slightest movement appears in the detection zone, the circuit closes. As a result, all devices connected to the sensor are turned on. If there are no movements, then the circuit is opened, and all devices are immediately disconnected.

LED lights with a motion sensor are widely used in a variety of areas. But most often they serve to ensure the security of lighting at home, but also for temporary inclusion. A complete system that allows to increase the security of the home includes sirens, spotlights and hidden CCTV cameras. All these devices are sensitive to the appearance of people in the zone taken under protection.

In an apartment and office, as well as on staircases and in corridors, sensors are usually present in lighting fixtures and are not used at all to protect the premises. These lamps with a motion sensor perform a completely different task - they save electricity. After the first month of use of such light sources, you will notice that the figures in your electricity bills will significantly decrease.

Lamps with a motion sensor easily connect to the network and do not need special care. However, do not forget to regularly wipe them with a rag or sponge, because accumulated dust can cause allergies.

You can install sensors that respond to movement on the ceiling or on walls. Nearby there must be an electrical appliance that controls its operation. Ceiling sensors have a maximum viewing angle - up to 360 degrees. As for models designed for wall mounting, they have a much smaller viewing angle - from 90 to 240 degrees. Therefore, such sensors cover and control only part of a residential or office space.

You can configure the motion sensor for your own needs. The most important parameter is the time interval for switching off the device, as well as the level of sensitivity and illumination. In order for the sensor to work correctly in the daytime, it is necessary to choose the right level of illumination. The values can be set from 5 seconds to 10 minutes.

When choosing the parameters of the sensor, you need to take into account the features of the room in which they are installed. The location of the doors and the main ways of movement of people - all this plays an important role in the operation of the device. Many people think that to connect the sensor, you need to call a professional at home or in the office. In fact, this is not so. It is not harder to connect it than to connect a conventional switch to the network. Attention! Before working with the wiring, make sure that you have disconnected the power supply in the entire apartment.