How to insulate windows

With the onset of cold weather, the question is how to insulate windows? Often they are not very tightly closed, and as a result, dust enters the room, and drafts also occur. Depending on what kind of windows you have in your house, you need to choose a suitable insulation. For wooden windows, foam strips with a thickness of 3 mm are perfect. They need to be glued along the perimeter of the frame, except for the side on which the loops are located. Before gluing it is desirable for the frame to rub a little with sandpaper for roughness. You need to start sealing from the outer, and then the inner side. In case of repair or painting, the foam strips must be removed and the surface treated with a solvent.

How to insulate windows with metal strips?

For insulation, you can use special metal strips (racks) made of stainless steel. Such bands are very durable and elastic. They are attached using cadmated studs. Before attaching the strip, it is necessary to cut it to obtain the desired length. At the junction of the bands, they are superimposed on each other by approximately 3 mm. The edged side of the strip should be located at the bottom, and the narrow edge at a distance of approximately 1 mm from the scar. Carnations should be nailed at a distance of 3 cm from each other.

How to insulate windows with putty?

In order to maximize the heat in the house, a special role is played by the putty for the glass, which ensures better fixing. To make it, you need to mix 15 g of linseed oil with 80 g of ground chalk and roll it out with a wooden rolling pin to a homogeneous state. Put the putty put carefully on the frame, wait until it dries, and then cover it with a waterproof varnish. Putty should be checked periodically, and if it is cracked, remove with a knife, and then apply a new one. You can store putty for a long time in oiled paper or under water.

How to insulate plastic windows?

Most often they are quite tight, but there are situations when they need to be insulated. This can be factory marriage, poor quality installation, the appearance of deformation under the influence of strong cold. Before proceeding to the insulation of such windows, it is necessary to find the deformation sites, check and, if necessary, replace the hinges and latches. Then you need to wash the window and wipe it with a dry cloth, so that it is not dirty and the insulation materials are well fixed. Fill the slits with a silicone sealant and a construction gun. Apply a special sealing tape suitable for your window (for example, a tape type D is used for gluing gaps from 3 to 7 mm), without drawing too much. Then it is necessary to cut a special heat-saving film to the window dimensions , which passes the light and keeps the heat, and fix it with a double-sided adhesive tape to the window frame, and then additionally strengthened with the buttons.

How to insulate windows with your own hands using gypsum board?

First of all, it is necessary to pay attention to the outside of the window and cover the slots with tile adhesive or concrete solution. Then you need to deal with the slots on the side of the room. To do this, prepare the work surface so that it is even. Using pliers remove excess foam, if necessary, clean the wall of surplus concrete and plaster. Identify and cut the blanks under the shape of the sides and top of the window frame. Attach the resulting sheets of gypsum board to the wall with screws. The remaining cracks should be covered with putty, and when it dries, rub it with fine-grained emery paper, wipe off the dust, and then paint.

How to insulate windows, which way is more suitable for you, you can decide for yourself, using the advice provided.