HomelinessDo it yourself

How to install the toilet on the tiles and concrete floors?

Modern comfort conditions involve the use of sanitary ware. Therefore, you can not imagine housing without such important equipment of a bathroom as a toilet. Its installation requires a competent approach and installation of supply lines. A qualified specialist with the relevant knowledge and experience can perform the work. How to install the toilet yourself? Installation of plumbing equipment can be done by one's own hands with a certain skill of work and proper observance of technological stages of installation.

Installation of a toilet bowl on a tile

In modern apartments, houses, cottages installation of the toilet is made on the floor, laid out with tiles, using screws in the following sequence:

1. Identify the attachment points by "fitting" the toilet bowl to the place where it will stand. To do this, drill holes in the floor with a drill through the holes in the toilet seat.

2. Push the toilet temporarily to another place.

3. Place dowels made of plastic into drilled holes.

4. Install the equipment.

5. Manufacture liners for screw caps from rubber or plastic waste, as well as brass washers.

6. Tighten the toilet bowl by lubricating the holes beforehand in order to easily screw in the fasteners.

How to install a toilet on a concrete floor

When installing on a concrete surface, it is necessary to pre-clean the floor and the bottom of the toilet bowl from contamination. Then it must be treated with a degreasing agent and glued with a chemical adhesive. The glue can be made from the following components: solvent or plasticizer, epoxy resin, hardener and filler.

How to install a toilet with glue? The technology of preparation of the adhesive mixture is as follows:

- heat the epoxy resin in a metal container using the "water bath" method;

- add plasticizer and filler to the resin;

- Mix the solvent and hardener using a metal container, then add filler.

The prepared adhesive should be used as soon as possible (no later than two hours after breeding). The solution is applied in four places to the bottom of the toilet bowl with a special metal spatula. The technology of installing the toilet bowl is as follows: position the toilet outlet in the extension of the sewage outlet, pressing firmly against the floor. After the completed work process, the toilet is not recommended for use for twelve hours in order to completely fix it to the floor.

How to install a toilet bowl with mastic for plastics, ceramic materials, expanded polystyrene? In order to distribute the adhesive evenly over the surfaces, it is necessary to make the plumbing rotations together with the drain tank (as far as possible) several times in one and the other side. Then you need to wait a while until the equipment is completely adhered to the floor.

After the toilet is securely fixed, it is necessary to remove the gap between the outer surface of the outlet bell and the inner surface of the outlet outlet of the sewage outlet. Strong sealing completely prevents the flow of water to the floor. As a cushioning material, harnesses, patches, oiled rags are used.

The clearance between the toilet bowl and the outlet to the sewage pipe is sealed with a screwdriver. The seal is pushed in such a way that a groove with a size of up to 1 cm remains from the edge of the surfaces of the branch pipe and the sewer pipe. The remaining space of the gap must be filled with cement mortar.

Correctly observing the entire technological process of fixing the sanitary equipment, you can be sure of the reliability of fixing the toilet. The exploitation of such a thing will not bring disappointment and inconvenience. With recommendations on how to properly install the toilet, can be found on special websites on the Internet.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.delachieve.com. Theme powered by WordPress.