How to install a curtain rod?

When completing the roofing work, do not forget about such details as gutters, cornice overhangs and slats. Since the qualitative result (a solid, non-draining roof) largely depends on these small, but such important elements. Consider how to install the cornice.

Cornice strip

Cornice lath (overhang) is classified as additional elements of the roof, while it performs both a decorative function and a protective role. This detail preserves the lower level of the crate and the frontal wooden elements from the effects of atmospheric precipitation. It also protects the sheets of roofing from all kinds of deformations. The bar for the cornice is made of metal and plastic of a variety of shades, which is important when selecting the building material for the roofing and gutter system.

How can I fix the cornice bar?

1. Due to the formation of the projection of the cross bar (tightening). At the same time, for strengthening the fastening of the rafters with bearing surfaces, special devices (headscarfs, nozzles) are provided. In this case, the structure of the roof will resemble the shape of the fungus, and this system is usually provided for the construction of buildings from wood and frame-shield devices.

2. By discharging the rafters beyond the outer wall level. In this case, to protect against the blowing of space under the roof under the overhang set the brick cornices to the upper level of the farms. Such a device is used in brick and stone structures with overlap of reinforced concrete.

Eaves canopy installation

The curtain rod is installed in such a way that it directs the running water through the gutters into the drain. When carrying out assembly work, it would be nice to take note of the following points:

• The overhang of the roof, or the removal of this structure should be at least 0.5 m. When organizing the drainage through rainwater, this value can be reduced.
• Mounting of the cornice should be done in such a way that there are no cracks, holes, etc., as otherwise the attic room will be blown. And this, in turn, can lead to significant heat loss in the house.
• The overhang must be installed before the roofing sheets are fastened, and the bar must be tightly connected without gaps. Only in this case there will be no noise from the gusts of the wind.
• Elements of the cornice should be lapped over the length (range 5-10 cm).
• The bar is attached to the frontal board and cornice with the help of galvanized nails or screws, while the fastening step should not exceed 30 cm.
• The edges of the waterproofing layer of the cornice must be laid over the lower level of the crate and overhang.

This device allows you to protect the inner layers of the roof from the effects of moisture and wind. The considered additional element differs in a variety of forms, it all depends on the roofing. Recently, a very popular curtain rod for metal tile, as this material is most often used for decorating a roof. And to pick up the mentioned detail to the designed roofing structure will not be difficult for you.