How to glue an Intex air mattress easily and quickly

Inflatable mattresses Intex quickly entered into our daily life. They are very convenient: they can be used at home, when visitors unexpectedly arrived, and in the field, living in tents. They are quite capable to replace a high-grade bed thanks to presence of a velor covering, very pleasant to the touch. But, unfortunately, it often happens that holes appear on the surface, and we begin to look for an answer to the question of how to seal an Intex air mattress. Although sometimes it happens that a leaky thing is simply thrown out. But how to glue an inflatable mattress Intex, has long been invented.

Materials for repairing an inflatable mattress Intex

The company produces a special kit for repairing damaged products. It includes glue, a patch material and a transparent film. This procedure is very simple, takes a little time and can be performed even in marching conditions. Some craftsmen, when asked about how to seal a seam of an inflatable mattress, suggest using a conventional superglue. But this will only help for a short time, then the mattress will again let in air, and it will be more problematic to paste the patch again.

Sequence of actions when repairing an air mattress

Having found a hole or a cut on the surface of the mattress, it is necessary to clean the space around from the fibers of the velor covering in a radius of approximately 2 cm. This can be done with a solvent or a liquid for removing the varnish. After applying the liquid to the surface to be cleaned wait about two minutes, and then remove the adhesive layer with the blunt side of the knife or spoon. This procedure is done until the surface is completely cleansed.

How to properly seal an air mattress?

To repair the mattress for many years to come, before glue application it is necessary to thoroughly degrease the surfaces to be glued with acetone, a solvent, and if they are not (for example, in nature), alcohol should be used. At the place of rupture or cut, apply a transparent film, which is included in the repair kit, and draw it, retreating 3-5 cm from each side. With a transparent film, this is much easier to do.

After that, from the material included in the repair kit, we cut out a similar patch of the same dimensions. Place the cut on a flat surface (in nature it can be just a board), overlay the patch and outline it with a pencil. This place is degreased once again: so there will not be any further questions about how to glue the Intex inflatable mattress so that the patch does not lag behind. And on the patch, and on the mattress with a brush, apply a thin layer of glue, leave for 15 minutes, so that it will dry up a little. Once again, repeat the same procedure, only the drying time is reduced to 5 minutes. In general, 15 minutes - this concept is quite relative, because much depends on the ambient temperature, air humidity and other indicators. It is necessary that the glue sticks to the hand a little, but it is dry. Before gluing the patch, the surfaces to be glued must be slightly heated. This can be done with a hair dryer. After heating, firmly press the patch to the mattress and iron with a roller so that no air bubbles remain between them, put the load on top and let it dry for 24 hours.

That's the whole answer to the question about how to glue an inflatable mattress Intex.