We make rings with our own hands

If you are interested in the question of how to make rings with your own hands, then this material is intended for you. There are many variations of homemade jewelry, only a few of them will be described later.

For the first ring with your own hands you will need a pair of beads and wire. Naturally, in addition to the materials that will be used to create the decoration, you will also need tools, among which you can identify pliers with a thin nose, as well as wire cutters and preferably round-nosed. To facilitate the work, you can stock up with an adhesive tape, a marker, as well as a round shape for rings of different sizes, which may not be available for you. It can be replaced with any round object, the diameter of which is slightly less than necessary. The wire should be such that it normally passes through the hole of the bead that you use. In the future, it will be possible, if desired, to adjust the size of the ring on the arm.

Now you can go directly to making the ring yourself. First you need to cut two pieces of wire, the length of which should be three times the required size of the ring. In the middle of each of the segments you need to wear a bead. Now you need to take pliers with a thin nose, and then bend the wire down at right angles. When you bend both wires, place the pieces next to each other. One bead needs to be placed slightly higher than the other, and the wires must be positioned relative to each other in such a way that the base of the ring is flat. They can be attached with adhesive tape for convenience.

Now, to create a ring with your own hands, you need to make another piece of wire coils around the base, fastened with adhesive tape, as close as possible to the nearest bead. Mark the marker to the desired length, and then continue to do the turns. The wire should be wound up to the required length, and then cut off the remainders with the wire cutters, and firmly fix the wire to the base with the help of pliers. It was the turn of the metal form for the ring. We wrap the workpiece around it until we get the ring. Now you need to prune the remaining ends of the ring, making them look like a cascade. Using kruglogubtsev of them you need to make curls. If you use expensive materials for making a ring with your own hands, then the product will turn out to be chic. You can, for example, take silver wire and Czech beads.

If you are interested in the question of how to make a ring with your own hands from paper, then there is an answer to it. You need the following: beautiful colored paper, clerical glue and PVA glue, scotch tape, scissors, round object, the diameter of which coincides with the diameter of the finger. The ring, which is offered for manufacturing, will be 5 millimeters wide and 2 thick. For this thickness, you need to make strips of paper with a total length of one and a half meters. One end of the paper tape should be fixed on the basis with the help of adhesive tape, grease the strip as much as possible with office glue, and then wind up as many turns as it takes to achieve the optimum thickness. The last bar should have a drawing that you would like to see on your ring.

Now it is time to process the product to give it strength. Here we will be helped by PVA glue, because when it dries it becomes completely transparent. It must be poured into a small container, and then immerse the ring there. The glue should soak it well, especially the butt ends. Dry the ring in a suspended state, it is desirable to periodically turn it up so that it does not stick to the drying site. After drying, the glue will become transparent, so you will see the selected picture.

Try to make jewelry yourself, then wear them with pride.