Solution: the drive does not open

A frequent malfunction experienced by PC users is the problem with the drive. If there is a problem, you do not need to immediately take the computer to a service center. There are several ways to fix the problem yourself. Here's what you need to do if the drive does not open.

How to open the drive:

So, the problem is obvious, and you need to quickly retrieve the information carrier. First, use the simplest algorithm: "Start" - "Computer" - "Eject Disk".

The drive does not open: the mechanical method

If the combination of commands does not help correct the problem, try removing the disc mechanically. To do this, take a needle (a spoke, a straightened paper clip) and insert it into the hole on the front panel of the drive until it stops. When exposed to the lever, the CD-ROM should open slightly. Then we palm the tray with your fingers, push it out and take out the disc.

A knife with a blunt end can serve as an auxiliary tool. Pressing the button, pull up the tray with a knife and try to pull it out. The main thing here is to act very carefully so as not to damage the drive.

Alternatively, you can disconnect-connect the interface wires, and then do one of the above procedures.

If nothing has helped, you should remove the drive itself and inspect it for damage. In PC, unscrew the side / rear wall, disconnect the cable and take out the drive. In a laptop, this operation will require more caution and skill. In most models, you need to remove the keyboard to remove the drive. But in ASUS the convenient location of the drive does not make it difficult to access it. To do this, just turn the laptop over and unscrew a few screws.

All of the above measures should be taken when the computer is turned off.

Read more about why the drive does not open

Even if you can remove the disc from the tray, you need to determine the cause of the problem. The drive can become jammed due to a malfunction of the magnetic latch, which is responsible for the reliable location of the drive in the drive.

The weakening of the rubber belt, which pushes the tray, also provokes a problem. At first it can be treated with rosin, in the future, the weakened passive needs to be replaced.

The reason why the drive does not open can be covered in cutting one of the teeth with which the gear is in contact. It makes the tray move with the disc. Because of this problem, the drive emits a creaking sound when opening / closing, or even jams. The only way out is to restore the tooth. You can make it from hot plastics at home. If you are not sure that you can do it yourself, it's better to take the drive to the workshop. This procedure will take very little time.

Damage can be of a purely mechanical nature: dust, small foreign objects have got into the drive. "General cleaning" will ensure the normal operation of the device. If the problem lies in the malfunction of the motor, the drive must be replaced with a new one.

Spontaneous opening / closing of the drive

If the drive is opened and closed, the cause of such a problem may be the result of the malicious program, the mechanical failure of the loop, the closing sensor or the drive itself. Most often spontaneous extension of the tray provokes factory defects or damage caused during the operation of the device.

First of all, you need to thoroughly clean the drive and inspect possible damage. If the cleaning did not bring a result, it is necessary to refer the drive to the workshop. Most likely, replacement of concrete details is required. Although in most cases it's easier to buy a new drive. Now you know what to do if the drive does not open.