Roofing Material Phylysol

In the modern construction business, a special place is given to waterproofing. With the advent of new materials, such a nuance has ceased to be considered difficult, and the quality of the types of materials themselves has also increased. Frankly, as soon as I needed to choose such material, I was slightly embarrassed, because the choice was very extensive, but my knowledge is not enough to choose. And then I researched the most suitable proposals, and therefore now I have the opportunity to tell you about my own research. I'll start with an isoplast. Buy isoplast EPP, means to provide good waterproofing of the roof. This polymer-bitumen material, which is installed on the roof by fusing. Before you buy an isoplastic, you must clearly understand its specificity. The most important detail is its composition. This material is made from low-oxidized bitumen, attack polypropylene. For the base, glass cloth or a non-woven polyester base is used. Also, I would single out the phylolis at a low price, found in some online stores. Among the qualities I note the following: gluing indexes, excellent elasticity, high resistance to thermal effects. In a word, the isoplastic perfectly corresponds to the insulation of both sloping and flat roofs.
This review could not be considered complete without a linocrom. This material is intended for insulation of bases or roofs with a small slope. To acquire a CCI lindict is to protect your own housing from problems with humidity. It is made from a solid organic base that does not yield to moisture. Bituminous binder coating is applied to the substrate on both sides. In this case, the lower surface of the material is processed by a readily melted film of a polymer substance, and the other side by a mineral coarse-grained powder. The material is welded with a propane torch. Before the beginning of the work, the base must be prepared in detail. It is better to fill the sandbox with a sand-cement screed or primed coating. There are a couple of variations of this insulating material, however I would recommend buying a CCI lin.
Although, it should not be forgotten that waterproofing is necessary for every building. The most popular today is waterproofing in rolls. As well as roofing waterproofing, the roll coating guarantees safety from penetration into the base of humidity by applying insulation to its exterior. So, when using both types of waterproofing simultaneously for the roof and the foundation, it is possible not to worry about the difficulties associated with the penetration of moisture into the building. Separately it is necessary to note a technoelast. Now everyone is able to buy a technoelast at a low cost, when only they will spend some time searching for the implementor. This material will be used to insulate both the roof and the foundation. Its multifunctionality is due to the excellent flexibility of the material, and to the same its durability. The material retains the polyester base of the bitumen-polymer material, protected by granular powder or polyester web. In order not to be mistaken in choosing, one should be very attentive, look at the name. The type of protective layer is indicated by the corresponding designations in the material name.