On how to find water for a well

Usually, after acquiring a site for the construction of a dacha or a country house, the new owners first try to dig a well. This desire is quite understandable - without its water it is very difficult to plant a vegetable garden or conduct construction work. If the area of the site is small, and nearby neighbors have already managed to solve this problem, then there is nothing to worry about. But what to do if there is no one nearby, and the layout of the house, garden, garden and surrounding buildings depends on where the future well will be? And anyway, is there any point in digging it? How to find water for a well? We will try to answer these questions in our article.

How to find water for a well - method # 1

This method is based on observation. First of all, you should try to look for external signs of occurrence of underground groundwater. In particular, pay attention to the vegetation with bright green and dense leaves. If the site has places in which it remains vigorous and violent, while the grass and flowers nearby begin to wilt and dry up, this is a clear indication of the proximity of the water. The availability of moisture-loving plants on the territory , such as sedge, reeds, birch, mother-and-stepmother, etc., also speaks volumes. With their help one can not only determine the best place for the well, but also try to determine the depth of the aquifer. For convenience, we group some data into a table:

Pets can also help in this matter. So, cats and dogs choose the most damp places in the heat for rest, and horses that are thirsty, if they feel water near them, hit the ground with hooves. Geese in such places like to carry eggs, and after sunset mosquitoes and mosquitoes begin to swarm here.

How to find water for a well - method # 2

Biolocation was used for this purpose by our great-grandfathers. At that time, the search for water was carried out using a vine bent in the shape of the letter "G". Now in esoteric shops you can not only find aluminum frames and pendulums for every taste, but also get detailed guides on their use. Then these frames can be used to check the presence of geopathic zones, the strength of the bioenergetic field of households, etc. The method is certainly unconventional, but why not use the ancient knowledge for additional verification? It remains to be said that the location of the water is revealed by crossing the frames.

How to find water for a well - method # 3

This method is called weighting, because to check the future place for digging out the well, weighing the desiccant material (red brick, silica gel), buried for a day at a depth of 50 cm is used. Just before that, it is well dried and covered in an earthen pot. Then we weigh and close the vessel with a non-woven stopper. The heavier the later the vessel, the closer to the ground are the ground waters.

How to find water for a well - method №4

Wait for the onset of hot summer days and early at dawn or before sunset, carefully inspect the proposed site. If a swirling or fogging mist appears above its surface, this will be another confirmation of the fact that underground groundwater flows nearby.

How to find water for a well - method # 5

According to scientists-surveyors, waterproof layers usually repeat the terrain surface according to their relief. Therefore, it is commonly believed that the well is best to dig in the place of basins and hollows, surrounded by hills and hills. At the same time, in order to find out for sure whether there is water in the proposed place, it will not be superfluous to produce reconnaissance drilling. We hope that now the question "how to find water on a site for a well" is removed from the agenda, and you can proceed directly to the robots themselves.