How to paint the ceilings and not upset

Repair in full swing, disputes over the choice of the color scheme of the room were left behind, the materials and tools were bought, the space to the maximum freely - you can start creating. But something stops. You just can not decide where to start? Well, start with the ceiling. If in your plans there is no order and installation of a tension structure, then you will be interested to know how to properly paint the ceiling. The process is time-consuming, and the result largely depends on your patience and accuracy.

Why do we start work from above? It's just that no matter how you insure yourself, but the droplets of paint will fly down anyway. Why once again get upset and scold yourself for just a bed, but already hopelessly spoiled flooring? Therefore, we act reasonably.

Pre-roll the polyethylene film on the floor (of course, they have not touched the floor yet, but why bother with rubbing the spots); Places that can not be tinted, pasted with special paint tape. Before painting the ceilings, we measure the required amount of color. I hope you remembered to prepare the surface? The primer level the surface and give the desired density, preventing the paint from peeling off.

For the coating to lie flat and not "strip", it is necessary to apply it correctly. The main thing in the problem of how to paint the ceilings is always to follow the direction from the light source (window) to the walls.

On the perimeter we work with a wide brush. Keep it correctly: the flat part is tilted to the surface, gradually increasing this angle in the direction of motion. Do not apply too much pressure on the brush to prevent staining.

The first layer is superimposed perpendicular to the window. Let the paint dry out. Do not rush the process by placing heaters in the room. Just spend, paying bills for electricity, and the fresh color will bubble. Be patient and wait for the composition to stick to the surface itself.

How to paint ceilings repeatedly? You need to drive the roller from the light source, but already moving parallel to the window. The second layer lies crosswise against the first coating.

The roller acts delicately. Evenly pressing, we hold the strip, not looking up from the surface for an instant. The next strip is led, slightly superimposing it on the previous one. It's okay if there are traces of the edges. They are neatly rolled perpendicular to the main direction.

Avoid drafts in the room where the finish is being carried out!

To the result of their own labors pleased you as long as possible, think carefully about how to paint the walls. In the bathroom or in the kitchen, the paint must successfully withstand moisture. Therefore, latex formulations that are based on acrylate, will not peel off after a month. And antifungal supplements will not give mold any chance. For concrete, brick surfaces, both water-based emulsion and acrylic are suitable.

Of course, even if you follow all the recommendations on how to paint the ceilings, you can find small defects on the already finished coating: marks from the roller or brush, small swellings. Nothing wrong! Deficiencies are cleaned with sandpaper and painted again.

Do not rush and do not be nervous: the calmer you will be, the more even the paint will fall. And do not scold yourself for minor mistakes, which can always be easily corrected.