How to make turntables from plastic bottles in various ways?

Very often young parents and not only have a question how to make turntables from plastic bottles. This may be caused by the desire to create a beautiful toy for your child or decorate the playground on which it is played. Also, such crafts draw the attention of gardeners. With the help of such simple adaptations, gardeners and vegetable growers struggle with a very serious pest - cabbage. The solution is quite simple. On the backyard there is a turntable, which makes noise. It is this sound background that repels such pests according to popular beliefs. So this question, how to make turntables from plastic bottles, is not so rare.

What do you need?

To begin with, it is necessary to prepare all the tools and materials that may be needed in the process of work. Necessary materials:

• Plastic containers;
• Heat shrink;
• insulating tape;
• paint;
• wire;
• Plastic gaskets for fixing.

Also the turntable is made with the help of a certain set of tools. You need:

• scissors;
• marker;
• Ruler;
• The curvilinear;
• awl;
• knife.

All this is better to prepare in advance, so that later in the process of creation there were no unpleasant surprises.

Toy or decoration of a playground

At the initial stage we make a support from wire. To do this, bend it in the form of the letter "G". The upper part should be very short. At the bend point we put the PTFE gasket. It must be securely fixed. If it scrolls, then you can wrap the wire with electrical tape and put a lock on top of it. The lower part of the rack is wrapped with electrical tape. If desired, it can be replaced by heat shrinkage, which is then heated by a cigarette lighter. In this case, the length of this section should be limited to fluoroplastic liner. Then take the plastic container. It is best to use a capacity of 0.5 or 1.0 liter. We cut it in half. Next, we do markup with a marker and a template. We cut the blades and wrap them in one direction and at a certain angle. Next, remove the lid. We make in it a hole of such diameter that the wire can easily pass and return it to its place. At the next stage, this turntable must be properly decorated with paint, which then must dry. Then this propeller is put on the wire and finally fixed with a second fluoroplastic gasket. To avoid possible injuries, the end of the rack is tightly wrapped with electrical tape. On this the most simple turntable from the bottle is made.

Protection of infield area

The previously described construction of a propeller from plastic containers is not applicable on the plot of land. For these purposes, a modified spinner is used, which has a higher degree of stability. It is made as follows. In the container, two holes are made - in the lid and in the bottom, strictly opposite to the other. Then, marking the blades is done, which are then cut out of it with knives and scissors and bent to the required angle. Then this container is put on the middle of the wire, fixed from each side with PTFE gaskets. Then the wire bends in the form of the letter "P". A greater degree of stability is provided by two legs instead of one. Such a method of how to make turntables made of plastic bottles is much more complicated and less commonly used.

Summary

Something super complicated during the manufacture of such propellers there. Even a beginner can solve this problem without problems. There are two ways of how to make turntables from plastic bottles. One of them is simpler and most often it can be seen as a decoration for a children's playground. But the second is a little more difficult and it is recommended to use it on the backyard for protection against pests.