Ethernet controller: installation, configuration and operation

The Ethernet controller is an important component of modern computers. It allows you to connect them to each other in a local computer network, because this device allows them to exchange information among themselves. The proposed article will be devoted to installation, adjustment and operation issues. Beginners are afraid to conduct the first two operations on their own, although, in fact, nothing is complicated in this, and everyone can easily cope with a similar task.

Installation

Such adapters are of two types:

• Integrated.
• External.

The first of these are now installed on most modern PCs. They are implemented as a separate chip on the motherboard. A simple and convenient solution, which does not require additional actions, is its main plus. But the drawback is that if you fail, you will have to install an external ethernet controller. If you have a new PC and already have such a device, then this step is skipped and proceed to the next. Older computers do not have an integrated network adapter. Therefore, you have to install a separate device. In one case, it is an adapter that is installed in the expansion slot on the motherboard. Such a design is used only in stationary system units. The second option is a miniature adapter that needs to be installed in the USB expansion slot (a rectangular socket installed on the motherboard). Do not forget also that on the other hand in such a device there must be an external wire from the router.

Customize

Configuring the network adapter requires the installation of additional software, which in professional jargon is called the "driver". The Ethernet controller simply can not earn without it. In the case of integrated execution, this software is available on the CD-ROM that comes with the motherboard. And with its external implementation, there must be a separate carrier. In extreme cases, you can download it on another computer from the official website of the manufacturer. Then turn on the computer and wait until the end of its download. A message should appear that a new device has been found - the ethernet controller. Asus, Samsung, HP and other leading manufacturers provide for automatic installation of drivers. Therefore, we expect the completion of this operation, that is, the appearance of one of the two messages. In the first case, the necessary software is installed. Otherwise, you need to install it manually. To do this, install the CD-ROM in the drive and, following the instructions of the wizard, install the software. Then go to the "Start", then - "Control Panel". In it we find the "Network Management Center" and open it. Following the wizard's instructions, configure a new connection. If problems arise, you can call the provider's service center and consult. In the end, it is recommended to do a full reboot of the system.

Testing

At the final stage, we check the ethernet controller in operation. To do this, open the browser and enter the address: qip.ru. Then press Enter. If done correctly, you will see this search page. Otherwise, it is also recommended to contact the service center of the provider.

Summary

Within the framework of this material, the procedure for installing, configuring and testing equipment such as an ethernet controller has been described in detail. There is nothing complicated in this, so we take and do.