Bur for the well with your own hands: you will get water for the site yourself

The question "Is there water on the plot?" Is tantamount to thinking about whether or not to be a private plot in general. After all, this is life-giving moisture for garden plants, and for garden trees, and for domestic animals, and, of course, for humans.

The only suitable option is: equipment at the well site for water supply. This, however, is a laborious process, and not cheap. Whether a wooden frame is erected or concrete rings are mounted - as a result, this translates into an amount that the landlord can not afford. And it is simply unrealistic to produce works on the construction of a well .

It's another matter if attention is drawn to the well. This alternative version of the water supply of both the house and the infield has already been tested and successfully applied. The most important thing: with a job like drilling a well with your own hands, one person can handle it.

It is best to first carry out "reconnaissance on the ground": ask neighbors how deep the level of water in their well is relative to the surface. If 5 meters and less - such a well and the usual garden borer will master. But if you go deeper - do not do without self-made construction.

Do not be scared: any person who knows how to work with metal can make a drill for a well with his own hands. It is required to create a construction of three main parts: the actual boring, the adaptation for its manual rotation and the detachable pipe. Three logs will also be needed to build a simple tower in the form of a tripod and a winch cylinder with handles for rotation.

A spiral drill for the well is done as follows. One end of the metal rod is pointed. A steel disk 2-3 mm thick is cut in half. These halves are welded to the rod opposite each other 200 mm from the pointed end at an angle of 20 degrees to the horizontal so that the angle between them is 40 degrees. Two knives are obtained, the lower edges of which need sharpening. Such a drill for a well, created by itself, calmly pass through the earth and sand, clayey soil and fine gravel, but with a stone can not cope.

Well, if you have access to work in the factory or in properly equipped workshops. Then the spiral drill can be made from a strip of tool steel. To do this, it needs to be heated, twisted so that a spiral is obtained, the pitch of which is equal to the diameter, and then tempered.

When the tool suspended under a tripod rotates, it crashes into the ground with its knives and goes to the depth. Then, with the help of a winch, the drill bit for the well is pulled out of the hole with the help of loose soil. As the well deepens, it is necessary to build up the pipe. The connection of its segments can be threaded or bush, but in any case it must be firmly fixed with a cotter pin so that when the drill is rotated in the opposite direction there is no disengagement. Work ceases with the emergence of a liquefied water in the pit.

The drill for the well with their own hands, coupled with the devices, makes it possible to cope with the task and alone, but if two people take the job - fast and comfortable work is guaranteed.