Water heaters flowing "Electrolux": instructions and references

With the onset of summer, all urban residents are faced with a massive shutdown of hot water. This can not please, because it brings a lot of inconvenience. In order to survive interruptions with water supply and not counting the days when the next preventive maintenance is over, it is better to consider the water heaters flowing "Electrolux" in the store.

This equipment has the advantage of comparing with storage devices. First of all, such units have less impressive dimensions, are cheaper, and also quite easy to install. Among other things, the system does not store water, but heats it up with direct use. This indicates that the volume of the resource is not limited by the size of the tank.

Reviews about water heater brand Smartfix 2.0

Water heaters flowing "Electrolux" today enjoy wide popularity among consumers. You can follow the experience of many users by buying a water heater of the above brand, which has a shower and a faucet as part of the shower. According to the owners of apartments and private houses, this version of the water heater has a laconic design and high performance. It heats the water in a short time due to the use of powerful heating elements made of copper.

This device can be used to supply water with only one point of water intake. The flowing water heater "Electrolux Smartfix" has a hydraulic control system, which, according to users, allows maintaining the temperature of the liquid depending on the mixer settings and the flow amount. Operation of the device will be very convenient, since it is equipped with an automatic shut-off and turn-on function when closing and opening the faucet. As users emphasize, this model provides three power modes, which allows to increase productivity and save electricity.

Feedback on the safety and usability of the Smartfix 2.0 TS model

The flow-through water heater "Electrolux-SmartFix", as already mentioned above, is characterized by high performance. This company achieved by installing inside a powerful heating element. With it, you can receive two liters of hot water in one minute. Do not worry about the safety of operation, since the device has a pressure sensor, which is very popular with consumers. In addition, the water heater is equipped with a special thermostat, which protects the equipment from overheating. The model differs in that it has a shower and a faucet. It can be connected to a stationary mixer in a short time and is simple enough, it will be an excellent solution for the time of water shutdown.

Reviews of water heaters Smartfix 2.0 (5,5 kW)

If you decide to buy a water heater flowing "Electrolux", reviews about which will help you decide on the choice, then you can choose the above model. It has a higher power. Its cost is 3000 rubles, according to users, the price is acceptable. The capacity of the equipment of this model is larger and amounts to 3 liters of hot water per minute. On sale you can find this version of the water heater, presented in three versions.

If the device is marked with the letter T, this indicates that you have equipment with a crane in front of you. The letter S indicates the presence of the shower in the kit, while the abbreviation TS indicates that the tap will be used in tandem with the shower. During operation, water is heated to a temperature of 43 degrees, which is the maximum possible index. Users who purchase not the first model of a water heater, note that this performance is very compact, since it has the following dimensions: 14 x 27 x 10 centimeters.

Instruction manual: general information

Water heaters "Electrolux" will last a long time if you operate them under the appropriate conditions described in the manufacturer's instructions. For example, the installation of equipment is prohibited in rooms where the temperature drops below zero degrees. The use of the device is not accompanied by difficulties. Opening the tap of hot and cold water, you ensure the readiness of the water heater to work. After the cold water tap is turned on, heating can be started by pressing the button located on the front panel. If you want to increase the temperature of hot water coming from the tap, you need to reduce its consumption.

Installation Instructions

If you liked the water heaters flowing "Electrolux" and you purchased one of the models, it is important to make sure that all the rules for connection to the water pipe were observed. In the network, the water pressure can vary from 0.03 to 0.6 MPa. The device must be supplied with water from a reservoir with a water level of 4 meters or higher in relation to the level of the device. If you plan to use water for heating from a well, a well or a water tower, you should additionally use a coarse filter.

Instructions for connecting the electric power

Choosing a flowing water heater electric "Electrolux", you will have to connect electricity. Use this requires a three-core cable, the minimum cross-section of the wire is 3 x 2.5 mm ² , it must be made of copper. It is necessary to make an electrical grounding. In order to exclude the occurrence of air congestion and prevent the failure of equipment, the installation is best done strictly horizontally.

User's manual

If you purchased a running water heater electric "Electrolux", then you need to take care that absolutely all the rules of operation are observed. The user should remember that the installation of a mixer that can block water at the outlet of the appliance is prohibited. During installation, only the complete devices intended for the distribution of hot water must be used. After the tap is open and the heat is turned on, wait approximately 15 seconds until the temperature of the heating medium is stabilized.

Near the switches of the heating stage there is an indicator that will show when the heating element is in working order. If you need to turn off the device, you need to use the key, which is located on the front panel. The water tap should then be closed.

Security measures

The water heater "Electrolux", the instruction manual for which is presented in the article, should be used exclusively for domestic purposes. This indicates that the equipment is not intended for industrial use. Do not turn the water heater on when the power cable is damaged. This also applies to other injuries. It is important to ensure that the electrical cable does not cross sharp edges and does not come into contact with hot surfaces.