Homeliness, Tools and equipment
Self-adhesive wallpaper simplifies repair
How did our grandparents glue the wallpaper ? They first carefully measured the perimeter of the rooms and the height of the walls. Then they asked friends about where to buy wallpaper pokazatneyney. And, preferably, not domestic production. Then they went to the store and began to carefully select the rolls of wallpaper, making sure that the shades of color were at least approximately the same. The wallpaper was usually bought with a margin, since it was possible that the color of them even in one roll could vary from dark to light.
Having made a choice, you bring home a few rolls, and start to glue them on the walls. You do not breed glue in different containers, do not cut any edges, and you do not care about fitting the picture. Cutting off the roll of the desired length from the roll, and it is easier to make it so that the self-adhesive wallpaper already has a centimeter marking in advance, so you do not even need a ruler with a pencil, you can safely proceed to the label.
Immediately remove the safety sheet is not recommended, as this will complicate the process of stickers. And all the other manipulations will not cause any difficulties, and you can fully apply wallpaper on the walls alone. And if on the canvas suddenly formed an air cavity - a bubble, then it is simply pierced with a needle, and gently smooth this place with your fingers.
The only requirement is that the wall should be absolutely flat and clean. Otherwise, all the hillocks and other irregularities will be visible, but here you can "get out" by purchasing matte self-adhesive wallpaper. They will allow to hide surface defects, while the shiny film will only emphasize them.
Similar articles
Trending Now