How to paste a protective film on the laptop screen

If until recently, the best friends of the homebody were a sofa and a TV, then today this role goes to the computer. But the more honorable status of "do not pour water" applies to the communicative duo "man and laptop".

Virtually all modern technologies have a sufficient high degree of strength. The laptop is not an exception. Despite all the qualities endowed by the manufacturer, the laptop computer is not protected from many situations that can disable it. If, however, the display is protected from mechanical impact by a special protective film for the laptop, how can I extend the life of the product as a whole?

From what to protect the laptop?

The first and most common danger is coffee, tea or other drinks. Hitting them inside the computer can result in a short circuit. As a result, the keyboard adapter and the motherboard on which it is mounted are out of order. Repair damaged in this way, the product will cost a little less than a new laptop. However, things can end even worse if other components are damaged in the event of a closure. Here the consequences are more than unpleasant: you will not only have to buy a new computer, but also restore data on the hard drive.

No less dangerous for a laptop computer is dust. The action of its particles compared with the properties of abrasive powder. They get inside the device, accelerate the wear of mechanical components. In addition, dust accumulations can eventually affect the operation of the keyboard.

In no less protection and care requires a portable assistant's screen, which with time of operation is covered with all sorts of scratches and abrasions. Such minor damage can significantly affect the quality of the image. Known reliable and affordable way - a special film that allows you to keep the appearance of the product for a long time.

How to paste a protective film? Step-by-step instruction

Before sticking a protective film, you need to wash your hands thoroughly to avoid fatty prints on the screen. Then, using a special napkin, clean the screen, removing it from villi and dust particles.

After removing the film from the packaging, it is necessary to carefully separate its duplicating layer by a couple of centimeters. Sticky part to attach to the top edge of the display, then, gradually separating the unnecessary layer, cover it with the entire surface of the screen. In order for the protective film to lie flat and without air bubbles, the gluing process must be accompanied by smoothing with a plastic card or other device.

Perhaps, the film from the first fall will not go right. In this case, it can be carefully peeled off and installed again. How to paste the protective film repeatedly, if it stuck to small villi? To do this, it must be washed underwater and dried with a hair dryer. Quality film will not lose its sticky properties. However, the absence of a protective layer significantly complicates the gluing process.

How to stick a protective film in a wet kind? Of course, this process requires more patience. After moistening the film under the stream of water and shaking it, we apply it to the surface of the screen. Then, using a plastic card, we "run" out from under it the remains of air and moisture, which in parallel are soaked with a dry cloth. It is important to avoid getting moisture inside the device!