How to make the sauna correctly

The construction of a steam room consists of several stages. The adoption of bath procedures with good flooring is much more pleasant and comfortable. Therefore, in the locker room make a double floor, that is, first rough, and on top - already a clean flooring. Traditionally, a wooden or concrete floor is equipped in a Russian steam room . When you build a base, you always think about how to make a floor in a bath so that it is warm?

Wooden floor

The classic wooden floor does not lose its relevance. This material is environmentally friendly, and wood always creates a feeling of comfort. Wooden surfaces are aesthetically attractive, they are associated with stability, solidity. English scientists say that the presence of natural wood in the room is the prevention of asthma.

How to make a floor in the bath so that it was the best option? One of the best decking is a double wooden. Two types of wooden bases are mounted in the bath - leaking and non-flowing. Flowing need to be dried all the time, so the second option is more often used. Non-draining bases are mounted with a slope so that water drains into the drain hole. In addition, they must have a rough flooring.

The rough floor

How to make the floor rough in the bath correctly? Pre-prepared concrete poles lay logs. Support chairs are made of wood, only under them a concrete pavement is necessarily poured. The distance between the beams should be 60 cm. Mounting in the bath leaking flooring, do not make a slope, and the non-flowing flooring under the slope. To get such a bias, do not cut on the uneven bars. Save on the beams is impossible, the thickness of the log depends on the distance between them and their number. In the place where the furnace will stand, it is necessary to further strengthen the bars. Then lay the boards, insulation and vapor barrier. After that, reinforce the bars, and from above establish a finishing floor.

Concrete floor in the bath has a drawback - it is cold, so it must be insulated. First of all, you can put a concrete base in 2 layers, and between them a thermal insulation. The bottom layer should include rubble. Before casting, set the guide beacons along the room. The level is done by checking in all directions. Concrete solution is poured from the corner of the room. After smoothing the first batch of solution, prepare the next. It must be ensured that there is no undulating transition when pouring the floor.

Warming

How to make a floor with a gasket in the bath? As a heat-insulating material, claydite, glass wool and perlite are used. The gasket is made from the following components: perlite (3 buckets), cement (1/2 bucket) and water (1.5 buckets). The resulting mixture is poured onto concrete with a thin layer. Such a foundation is considered reliable and durable.

Specialists also make water-heated floors. They consist of pipe systems that are in the screed. Electric warm substrates are also made by mounting electric cables.

Ventilation

This is a very important point, which should be paid special attention. For this purpose, a vent is made in one of the walls, and a box of tin or wood is mounted below. At the same time one end of the box goes to the roof, and the other goes down. Any owner of a bath - provided that he himself has built it - can share information from personal experience about how to make a floor in a bath.

Conclusion

Wooden flooring decorates the steam room - it becomes comfortable in it, and the body receives a charge of vivacity and health prevention for many years. If professionals take care of the matter, the floor in the bathhouse will be installed correctly.