How to connect the car stereo?

A radio tape recorder is a device that combines a tape recorder and a radio receiver. Often drivers do not represent a trip in the car without music. It helps to pass long hours en route. Always supports a certain state of vivacity, so necessary for the driver. With her help, you can collect all of the pieces and enjoy them on the trip. The car radio allows creating the effect of presence, there is no feeling of loneliness. And at the same time, music can always be turned off.

Therefore, the question of how to connect the car radio is of interest to many car enthusiasts. First of all, you need to be confident in your abilities. Any person can independently connect it to the car.

Firstly, there is an instruction manual for any tape recorder. Often it is not just packaged, but glued directly to the top cover of the device.

Secondly, modern cars use standard plugs for connection, which simply have to be connected with each other.

If the incomprehensible lines in the manual are questionable, and there are no standard plugs, here's a little guide on how to connect the car radio.

First of all, the installation process is affected by the type of device. There are single-block, that is, consisting of one part, car radio and two-unit, respectively, of two parts. When buying, you need to see if there is an option to install a dual-unit device, whether there is enough room on the panel board. After the choice is made, it remains to decide how to properly connect the car radio.

1. If the device you have selected does not have a dedicated power cable, then the connection via a battery or cigarette lighter to the radio is best.
2. Usually the power wire consists of yellow and red wires. The latter performs the simultaneous disconnection of the radio and the activation of the ignition. Yellow is used to tune the instrument. These wiring must be connected in parallel. If you are scattered and can leave the radio on, it is better to install a separate switch on the red wire. So it's easy to avoid unexpected discharge of the battery.
3. The blue wire is responsible for the antenna. After connecting the car radio, the signal is automatically transmitted to the antenna and back.
4. If you did not have a radio before this time, then, most likely, the speakers are not connected. Therefore it is necessary to conduct a 2-millimeter wire.
5. Now let's define the speaker system. The suspension for the speakers should be soft. It can be made of rubberized fabric. The diffuser should preferably be made of plastic.
6. The most optimal placement for the speakers is behind the rear seat. So they will not interfere with driving and provide optimal acoustics.
7. To fix the radio in the cabin, use a special frame. They are usually sold complete with a radio tape recorder. First, install the audio system in its proper place. Then, by bending the metal lobes, fix the system.
8. After we move on to how to connect the car stereo. It should be inserted until it stops, until a click is heard. This will mean that the radio is installed. The main thing - do not forget that during installation it is necessary to remove the negative terminal from the battery. Otherwise, the device will not work.
9. In the case where you need to remove the device, you need to open the metal petals and pull it out.

If this instruction can not help you in how to install the car radio, then it is better to contact the service center. Qualified specialists will solve this problem in an hour. It is better not to conduct experiments, connecting wiring, as horrible. After all, this way you can break almost a new radio tape recorder.