Power calibration error while writing discs

There are many myths about the cause that causes the message: "power calibration error". Most of such misconceptions pushes the average user to rather cardinal ways of solving the problem, such as buying a new drive, reinstalling Vindous, etc. Therefore it will be very useful to reveal the veracity of these or those statements.

Many feel guilty about the power calibration error, Nero. In such cases, it is suggested to delete the program and use another one. It really can help, but very rarely. It should be noted that the reason for this message is not the program. As a rule, in such cases, a disk or drive contributes to a warning due to contamination or incompatibility.

The development of this situation will be the appearance of a message in Nero: "power calibration error". The program, accordingly, remembers this and gives the user a cautionary inscription even when the problem is already eliminated. It's worth repeating that the likelihood of such a development is very low, and installing other applications for writing disks can help only a limited number of cases. In most situations, software from third-party developers will simply produce a burning error.

In fact, in most cases, the real reason for the "power calibration error" message is poor quality disks or incompatibility of the drive. Here, the search for the original floppy drive or the use of discs from other manufacturers may come to the rescue. In the vast majority of cases, problems arise only with DVD-R discs on a particular computer.

The same media, as a rule, will be quietly recorded on other drives, so do not rush to throw them away. If the user received a warning "power calibration error" during the recording process, then in no case should you be hot. The disk can be pulled out and recorded without any failures and errors on another drive, despite the fact that the disc for a long time stayed inside the computer where it was attempted to record.

Another way to deal with this problem may be to reduce the write speed of the disc. The fact is that when the drive is used, the laser power is reduced, and high-quality recording can be made only at the speed of 2.4x and 4x. Sometimes it helps to replace the power supply. A new unit must necessarily have more power.

When a message like "power calibration error" appears, you should refrain from such steps as reinstalling the operating system. In any case, this will be just an empty loss of time, since it will not effect any effect on the elimination of the problem .

If the drive is old and all the actions described above did not help, then only, of course, have to buy a new one. In such cases it will be useful to install a newly purchased drive without throwing out the old one. Using a new drive only for recording discs will significantly extend its service life, and reading discs can be performed on the old one.