Modern technology of building a house from a bar

Houses made of lumber are becoming more popular lately. This is due to a variety of factors, including their environmental friendliness. The technology of building a house from a bar may be of interest to so many. It is worth considering the main stages.

Foundation

The basic configuration of a wooden timber house measuring 6 * 6 meters assumes its installation on a foundation of columnar-type support. With a larger size of the house, it is installed on a strip foundation, not too deep, or on a columnar one, which has a monolithic grillage. The technology of building a house from a bar is oriented to the fact that it will be built of quality material with a cross-section of 150 * 150 mm. You can bite the cant, which will reduce the cost of finishing work. Jars are laid between the beams.

Installation of the first crown

The technology of building a house from a bar requires the installation of waterproofing before installing the first crown. As an insulating material is used stilogidroizol or roofing material. These materials protect the tree from direct contact with concrete, which does not allow the bar to rot. On the layer of waterproofing, the first crown is assembled, consisting of a bar 150 * 150 mm, and it must be treated with antiseptic from four sides. The technology of building a house out of a bar is focused on the fact that after that, sex lags will be installed, and then the rough floor. The floor lags are made of material with a cross section of 150 * 100 millimeters. They also need to be treated with an antiseptic. Laying the rough floor is done like this: to the bottom edge of the beams should be beaten bars 50 * 50 millimeters, and then the edging board, whose thickness should be 25 millimeters.

Assembling the walls of the house

The technology of building a house from a bar with its own hands prescribes that further it is possible to start assembling the walls of the house, as well as partitions inside. The main walls are made of wood 150 * 150 millimeters, and internal partitions - 150 * 100 millimeters. Jute is laid between the crowns of the house. The jointer joint between the crowns is made by means of wooden nagels, which are arranged in staggered order with respect to the previous crown. Docking of the outer corners of the house is carried out in a special way in the "warm corner". This design is almost non-blowing, which ensures minimal heat loss. Internal partitions need to be cut into the main walls of the building, and every fourth crown is sewn into the semi-tailed tail, thanks to which it is possible to fasten all the walls together, making the construction as rigid and strong as possible. When the necessary height of the walls is reached, it is possible to begin installation of ceiling beams, which are made from the same beam as the sex ones. The roof of the house can have any shape. The manufacture of rafters is carried out from a bar or edging board 150 * 50 mm, and the formation of a crate only from edging boards. Roofing can be any: soft tile, ondulin, corrugated board, metal and other types. The ruberoid is quite suitable as a temporary overlap.

Depending on the materials selected, a house construction estimate is compiled from the timber.