Circular carriage for own hand: manufacture and assembly

The carriage for circulars with their own hands is often made by beginning masters and specialists. This element is an indispensable tool in the workshop. With the help of it, it is possible to accurately cut the workpiece quickly and safely, eliminating the possibility of a return return.

Recommendations for work

If you carry out the circular carriage with your own hands, you must choose the size of the sled base, their parameters should be equal to the dimensions of the circular table. For supports, one of which is located behind, the other - from the front, it is necessary to use wood with straight fibers, like a cherry or maple.

The material should be moderately dense. It is important to make sure that the stops have perpendicular edges, and their length should correspond to the width of the base. When the circular carriage is being used by hand, it is important to ensure that the rear and front stops have an increase in the place where the saw blade passes.

A band saw allows rounding the sides of the stops for comfort and weight reduction. To carry out the guide bar, it is necessary to use hardwood, since it is sufficiently dense. The size of the bar should be equal to the parameters of the groove in the circular table. Considering the dimensions of the saw blade, it will be necessary to make a protective cover, and after rounding the near corner.

Recommendations for the assembly wizard

When the circular carriage is hand-held, it is important to remember that the protective cover must not act as a handle, it should not be operated while the carriage is moving. For assembly, the rear stop is fixed to the base, and in the lower part it is necessary to drill holes for the installation of screws.

In the groove of the circular table, you need to install a guide bar, which is pre-treated with a layer of glue. The base should be placed perpendicular to the saw blade on the guide bar, leaving the element in this condition until it dries completely. The next step is to take a few screws to strengthen the guide rail.

Conclusion

You can have a carriage for circulars with your own hands, a photo of which you can see in the article. After all the above works have been completed, it is necessary to turn the base so that the grooves on the circular table coincide. If necessary, then you can additionally use sandpaper or a scraper, with the help of which excess wood is eliminated.